10
Setup Steps
This thermostat features four programmable time periods per 24 hour day:
Morning, Day, Evening, and Night. The start time for each time period is
adjustable. The stop time for each time period is the start time for the next
period. Each time period, or day part may be individually disabled.
Select the Day to Program - Press the WARMER or COOLER to select
the desired Day or Week Part in the case of 5-2 (weekday – weekend)
programming.
Enable/Disable Morning Period - Press the WARMER or COOLER to select ON
or OFF. If the default ON is selected, then the Morning period will run complete
with the Mode and Set Points selected. If OFF is selected then the Morning
day part will be skipped and the thermostat will use the next day part that is
enabled.
Select Morning Mode - Press the WARMER or COOLER to select the desired
mode, which includes OFF. You may be limited by the available modes in
advanced Installer setup step#2. Press MODE to advance to the next step.
Select Morning Start Time - Press the WARMER or COOLER buttons to adjust
the time of day desired. Press MODE to advance to the next step.
Select Morning Cool Setpoint - Press the WARMER or COOLER buttons to
adjust the cool setpoint desired. This step will appear if Cool or Auto Mode
was selected in the step where the Morning mode is specified. Press MODE to
advance to the next step.
Select Morning Heat Setpoint - Press the WARMER or COOLER buttons to
adjust the heat setpoint desired. This step will appear if Heat or Auto Mode
was selected in the step where the Morning mode is specified. Press MODE to
advance to the next step.
Repeat Enable, Mode, Start Time and Setpoint programming for Day, Evening,
and Night.
“Copy Current Day to Next Day” is available - Press the UP button to Copy the
current day’s program to the next day. Press Mode again to continue copying
the following day.
Press the
OFF | RUN HOLD TO SET
button to exit
Time Period Programming at any time.
OFF
RUN
HOLD TO SET
OFF
|
RUN
HOLD TO SET
