7
4. INSTALL GLASS PANEL (WG
MODELS
ONLY
)
(
CONT
'
D
)
2. Carefully remove the glass panel
from its packaging. Remove glass
panel nuts (factory installed) from
both studs and set aside.
3. Insert glass panel studs in the
appropriate hood holes.
4. While holding the glass panel,
pre-tighten the previously
removed nuts by hand. Make
sure the glass panel is centered.
Then, using a 3/8" socket, tighten
the nuts completely.
5. Reinstall the electrical
compartment cover.
HD0561
G
LASS
PANEL
STUD
N
UT
5. PREPARE
THE
OPENING
CAUTION
Never use a hammer and screwdriver to remove the vertical or horizontal discharge knock-
out; this would damage the hood internal parts.
5.1 IC700
AND
IB700
MODELS
1
2
1
2
HR0068
V
ERTICAL
DISCHARGE
:
H
ORIZONTAL
DISCHARGE
:
V
ERTICAL
DISCHARGE
Using long nose pliers, remove the
knock-out located on the top of the
hood.
H
ORIZONTAL
DISCHARGE
Using long nose pliers, remove the
knock-out located at the back of
the hood.
See illustrations at right.
