12
11. INSTALL THE HOOD (IC700 AND IC700ES)
WARNING
!
BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
CAUTION
DO NOT REMOVE yet the protective plastic film covering the decorative flues (upper
and lower).
HD0417A
L
OWER
HOLES
LOCATION
U
PPER
HOLES
LOCATION
Ø
3/16”
TYP
.
S
IDE
VIEW
1. Align the hood and center it above the hood mounting bracket. Gently lower the hood until it
securely engages the bracket, and slightly pull it downward to make sure it is fully engaged.
2. Level the hood.
3. Mark the position of both
holes located inside lower
back of hood (as shown at
right). Also mark the position
of 2 of the 6 available upper
holes (one on each side).
Remove the hood. Drill
through both lower holes
using a 3/16” drill bit. Insert
the included drywall anchors
into both lower drilled holes.
Align the hood and center it above the hood mounting bracket. Gently lower the hood until it
securely engages the bracket, and slightly pull it downward to make sure it is fully engaged.
NOTE:
For horizontal discharge only
, make sure the adapter/damper enters the duct opening
and seal joint from inside the hood using 2” metal foil duct tape.
4. Secure the hood to the wall using 2 no. 8 x 3/4” screws for lower holes, and 2 no. 8 x 1½ for
upper holes.
12. REINSTALL THE BLOWER
(HORIZONTAL DISCHARGE ONLY - IC700)
HD0563
1. Position the blower on the back wall discharge.
Secure the blower to the hood using a 5/16”
socket, or a Robertson or a Phillips no. 2
screwdriver and the 4 previously removed
screws.
NOTE: In order to ease installation,
before mounting the blower,
prepare the screw holes by
screwing all 4 screws without
the blower, then remove and
mount the blower.
CAUTION
Make sure that the screws are well tightened before continuing the installation.
