16
NOTE: For better precision, the
illustration at right shows the
screws location on the left side
of the hood only; their location
is the same on the right side of
the
hood.
4. Slide the blower box in the opening
and secure the hood to the bottom of
the cabinet using 6 screws (
A
)
(3 screws on each side).
Secure the hood to the wall by
inserting a screw in one of the
3 available holes (
B
) on each side of
the blower box (1 screw on
each side).
F
OR
HORIZONTAL
DISCHARGE
ONLY
Ensure the adapter/damper enters
the duct opening and seal joint
from inside the hood using 2” metal
foil duct tape. Reinstall blower by
following step 12.
F
OR
VERTICAL
DISCHARGE
ONLY
Measure the length of metal duct required from the adapter/damper to the house ductwork.
Slide the duct over the
adapter/damper and seal joints using 2” metal foil duct tape.
5. Plug the hood power cord into the outlet.
6. Finalise the installation by following step 17.
16. OPTIONAL BUILT-IN INSTALLATION
(IB700)
(
CONT
'
D
)
HD0564
A
B
17. REINSTALL HYBRID FILTERS (ALL MODELS)
CAUTION
Remove protective plastic film covering filters before reinstalling them.
Rest rear filters edge on filter springs in the
range hood. Tilt up the filters into position.
Make sure filter tabs are securely engaged in
range hood front edge slots after installation.
HO0251
F
ILTER
TABS
