13
19. LED LIGHTING
18. REINSTALL GREASE FILTERS
HO0139
Using a Phillips no. 2 screwdriver, assemble the knob to each filter. The screw MUST BE on same end
than filter tabs. See illustration beside.
Rest rear filters edge on filter springs in the range hood. Using knob, tilt up the filters
into position. Make sure filter tabs (
A
) are securely engaged in range hood front
edge after installation.
HD0392
A
20. CARE
Grease Filters
Grease filters should be cleaned monthly. Remove each grease filter by pushing it towards the back of the hood, then tilt the filter downward
and remove. Use a warm detergent solution to clean the filters. Let them dry and reinstall them.
Grease filters are dishwasher safe. Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of the filter may
occur if using phosphate detergent or as a result of local water conditions — but this will not affect filter performance. This discoloration is
not covered by the warranty.
Interior Blower Cleaning
Remove the filters in order to access the blower. Use a shop vacuum to clean the blower.
Do not immerse in water.
WARNING
!
Before servicing or cleaning the unit, switch power off at service panel and lock service panel to prevent power
from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
!
WARNING
Do not touch lamps during or soon after operation. Burns may occur. Cannot be replaced by any other type of light
bulb or LED module.
The lighting of this hood is produced by two LED modules (included).
