MA-SE-RTL0-03-01 Manuale Rialto Triade Lido Eng rev1
Page 5 of 8
INSTALLATION/MAINTENANCE ADVICES:
In case the sounder does not work properly, verify if the LED located on the main board is flashing.
If it flashes, check the ANOMALY NOTICE CHART above.
MOUNTING:
1.
Screw the sounder on the wall and check if the tamper works properly;
2.
Insert the connection cables through the holes localed on the sounder base;
3.
If necessary, modify the default settings acting on the DIPSWITCHES as indicated in the charts here above;
4.
Connect the battery and the power supply to the control panel;
5.
Close both internal and external covers using the screws provided;
6.
Battery must have UL94-HB flammability rate;
7.
Power supply must be of SELV type.
Attention: not to have condensation in the sounder, it is important to avoid any air flow inside the duct. To such purpose, once the
sounder is connected, seal the hole using some silicon or any other plaster. This operation prevents condensation from forming inside the
sounder; condensation mostly appears in winter and it is usually caused by warm and humid air coming out of the wall where the sounder
is installed and passing through the holes located on the sounder base.
117.1 dB (Rialto LSX)
115.0 dB (Triade L/Lido LS)
115.5 dB (Rialto LS)
Diagram 1
