8
MANUALE TECNICO /
TECHNICAL MANUAL
Press P1 button of the sounder. LED DL1 flashes quickly and the sounder transmits the code.
The display lights up steady when a valid code is received to confirm memorization.
Every time P2 button is shortly pressed, the display will show the numbers 2,3,4,5,6,7,8 in sequence
and then again 1,2, etc..to memorize any possible additional sounders.
To exit from ATX3 programming:
Press P2 for at least 5 seconds. The display shows the central cursor and the receiver starts working.
After 3 minutes of programming time-out, there’s an automatic exit from programming.
To delete a memorized code:
Press P2 to enter the ATX3 programming menu. Choose the number of one of the already memorized
sounders (refer to steady-on corrisponding led). Press P1 for at least 5 seconds. The display starts to
flash waiting for a new valid code.
DIP-SWITCH DESCRIPTION
The dip-switches enable to: set the alarm time, change the kind of sounder modulation, bypass or
enable the On/Off sound signal, set the acoustics intensity on two levels, and bypass or enable the
On/Off optic signal thanks to dip-switches.
DIP1 DIP2 SOUNDER TIME
FLASHING TIME
OFF
OFF
30 seconds
30 seconds
ON
OFF
60 seconds
60 seconds
OFF
ON
120 seconds
120 seconds
ON
ON
120 seconds
300 seconds
DIP3 DIP4
SOUNDER MODULATION
OFF
OFF
High frequency sweep
ON
OFF
Low frequency sweep
OFF
ON
High frequency double tone
ON
ON
Low frequency double tone
DIP5
SOUND SIGNAL (BEEP)
DIP6
OPTICAL SIGNAL (FLASHING)
OFF
Disabled
OFF
Disabled
ON
Enabled
ON
Enabled
DIP7
BEEP INTENSITY
DIP8
NOT USED
OFF
Low
-
-
ON
High
-
-
On/Off system indication:
If dip-switches 5 and 6 are set in “ON” position, by enabling the sound and acoustic signals of ON/
OFF systems, the sounder will perform 4 flashes together with 4 beeps when the system goes “ON”
and a long flash together with a long beep when the system “OFF”.
