6
MANUALE TECNICO /
TECHNICAL MANUAL
DOGE AS1 AND AS1/P WIRELESS SELF-POWERED,
BI-DIRECTIONAL SOUNDER, WITH ALKALINE BATTERIES
DESCRIPTION
DOGE AS1 and AS1/P are wireless bi-directional sounders for outdoor use with LED flashing unit.
They work only with alkaline batteries. Doge AS1 and AS1/P work in combination with ATX3 or ATX2/S
devices. Powered by
5
size “
D
”
1.5 Volt
batteries.
The sounder has anti-removal and anti-opening devices and it is provided with an anti-foam protection.
The sounder can receive control signals for alarm activation from ATX board. Moreover, it transmit
supervision signal, low battery voltage verification and anti-tampering signals to the control panel.
Doge AS1 Model:
wireless alarm sounder for outdoor use with anti-foam and anti-shock device.
Doge AS1/P Model:
wireless alarm sounder for outdoor use with anti-foam, anti-shock and anti-
drilling device.
TECHNICAL FEATURES
Tension
Nominal power supply
7,5 Vcc (5x1,5 size “D” batteries)
Current
Standby consumption
100 microA
Maximum consumption
500 mA
Working frequency
433,92 Mhz
Transmitting module power
10 mW
Radio
range
100 m in open air
Working temperature
from -10°C to +40°C
Relative humidity
< 70%
Dimensions
327x216x117 (H x L x P)
SETTING
Remove the flash cover by pulling it downside and remove the cover by inscrewing the screw, then
remove the internal cover. Set the dip switches according to the desired configuration.
Connect the battery pack, memorize all the codes and check the functioning before sounder
installation.
In case of incorrect initialisation of the microprocessor, due for example to incorrect battery connection,
it will not be possible to memorize the codes. In this case it is necessary to remove the battery pack
and re-insert it, ensuring a steady connection.
CODES MEMORIZATION ON ATX2/S AND ATX3 MODULES
We suggest to memorize the codes before installing the system; temporary supplying can be provided
through the batteries of the sounder. This will make verification and codes memorization operation easier.
