Vemer Thermo GSM Bianco VE715900, User Manual

Page: 31 / 40

English
- 29 -
Thermo GSM Digital Thermostat User Manual
N SIM=3331234567
01.07.10
14:55:23
In this case, the writing “
(reg)
” is related to the measured temperature value
of the internal probe and indicates the probe (if there are two probes) on which is
performed the regulation.
MANAGEMENT OF ALARMS
The thermostat can be configured to send text message alarms to phone numbers
in the phonebook.
There are four alarm sources:
– minimum alarm if the measured temperature decreases a specified threshold
– maximum alarm if the measured temperature exceeds a specified threshold
– power supply alarm in case of blackout
– external alarm in case of generic alarm on the digital input
For each alarm source, it is possible to specify phone numbers in the phonebook to
send the text message.
The instrument is configured at the factory to send alarms to the first
phone number in the phonebook in the following cases:
– failure and restoration of the power supply
– measured temperature by the internal probe lower than 5 °C
– closed digital input status alarm (with delay of 10 seconds)
The following commands can be used to change this configuration.
Defining alarm recipients
It is possible to specify message recipients for each alarm source.
The command syntax is:
SEND ALARM MINIMUM
[recipient] …[recipient]
SEND ALARM MAXIMUM [recipient] …[recipient]
SEND ALARM EXTERNAL
[recipient] …[recipient]
SEND ALARM POWER [recipient] …[recipient]