22 VELUX
®
VELUX
®
23
1
2
3
Set-up of KLI 311/KLI 310 to operate VELUX INTEGRA skylights
Important:
The KLI must be the universal KLI 310 or the model match-
ing the product.
If a non-functional control must be replaced or if the control pad cannot
find certain products, you can make the products ready for registration
by manually resetting them to initial factory settings.
Note:
Reset products cannot be operated until they have been regis-
tered in the wall switch again.
1
Make sure the skylight is powered on (VSS/VCS)
2
Close the sash by pressing the button closest to the center of the
skylight (
A
).
3
When the skylight is closed, reset the skylight by pressing and hold-
ing the button closest to the center of the skylight (
A
) for at least
10 seconds. The skylight operator will run briefly back and forth
indicating that it is ready to be registered.
Note:
The skylight must now be registered in the wall switch within the
next 10 minutes.
4
Press Rectangle button on the wall switch for 1 second.
5
Press the stop key and then the DOWN key within 3 seconds. This is
only necessary at the initial set-up after installing the skylight.
The skylight can now be operated by the KLI 311/310.
4
5
1 sec
A
A
10 sec
max 3 sec
1 sec
