24 VELUX
®
VELUX
®
25
RESET
1B
1A
10 sec
10 sec
Set-up of KLI 312/KLI 310 to operate VELUX INTEGRA blinds
Important:
The KLI must be the universal KLI 310 or the model match-
ing the product.
If a non-functional control must be replaced or if the control pad cannot
find certain products, you can make the products ready for registration
by manually resetting them to initial factory settings.
Note:
Reset products cannot be operated until they have been regis-
tered in the wall switch again.
Reset the blind.
The solar-powered blinds can have two different designs:
1A
Solar-powered blind with sliding switch on the right, bottom side of
motor unit: Slide switch to the right and hold for 10 seconds.
The blind will run briefly back and forth indicating that it is ready to
be registered.
1B
Solar-powered blind with button behind door at the bottom of mo-
tor unit: Open solar battery door, press button behind the door for
10 seconds and close solar battery door.
The blind will run briefly back and forth indicating that it is ready to
be registered.
Note:
The blind must now be registered in the wall switch within the
next 10 minutes.
2
Press Rectangle button on the wall switch for 1 second.
3
Press the stop key and then the DOWN key within 3 seconds. This is
only necessary at the initial set-up after installing the blind.
The blind can now be operated by the KLI 312/310.
2
1 sec
3
max 3 sec
