Veloteq Owner Manual 2008 P. 7 of 15 2/18/2008
wheel will spin freely without a brake damping effect. (See Fig. 2)
Rear Drum Brake Adjustment:
To adjust the rear drum brake turn the adjustment screw located at the end of the brake line forward of
the brake assembly as above, test the travel of the brake handle and securely tighten the locking nut.
(See Fig. 5)
Take care to not over-tighten the rear brake! This will create drag on the motor
which may result in failure of the controller.
When the brake pad is worn down to ½ of the original
thickness it must be replaced. Return to your dealer for service if the rear brake becomes difficult to
apply. (See Fig. 3)
Chain Adjustment:
To adjust the chain link, turn the rear wheel chain adjustment screw as show in Fig. 4, until the chain is
allowed to turn freely. The chain slack should be approximately as shown.
