WS3080
V. 05 – 08/11/2016
5
©Velleman nv
synchronized instant reception
12 or 24 hour display
perpetual calendar
time zone setting
alarm clock
LED backlight
wall mount or standing free
5.
Overview
Refer to the illustrations on page 2 and 3 of this manual.
A
upper pole
F
side support
B
lower pole
G
rain sensor
C
top support
H
solar panel
D
anemometer
I
sensor shelter
E
wind vane + direction sensor
J
thermo-hygrometer (under shelter)
a
MENU button
d
DOWN button (
)
b
ENTER button
e
ALARM ON/OFF button(
)
c
UP button (
)
f
HISTORY button
1
Weather forecast
10
Outdoor reception signal
2
Barometric pressure
11
Outdoor humidity
3
Barometric trend
12
Outdoor temperature
4
Date
13
Wind direction
5
Memory
14
Wind speed/gust
6
Time
15
UV index
7
Indoor humidity
16
Rainfall
8
Indoor temperature
17
Light intensity
9
transmitter low battery indicator
18
Radio Controlled Clock (RCC) indicator
6.
Setting up the stations
1.
Connect the lower pole [B] with the upper pole [A].
2.
Place the anemometer [D] on the top support [C] and fix with a bolt and nut.
3.
Place the wind vane [E] on the top support [C] and fix with a bolt and nut.
4.
Place the top support [C] on top of the upper pole [A] and fix with a bolt and nut.
5.
Mount a side support [F] on the pole [A+B] and place the rain sensor [G] on top. Secure it with a screw.
6.
Mount the second side support [F] on the pole [A+B].
7.
Place the solar panel [H] on top of the shelter [I] and secure it with a bolt and nut.
8.
Make all necessary connections:
o
Connect the anemometer [D] to the wind vane [E] phone jacket.
o
Connect the wind vane [E] to the thermo-hygrometer [J] WIND phone jacket (left).
o
Connect the rain sensor to the thermo-hygrometer [J] RAIN phone jacket (right).
9.
Insert 2 x AA rechargeable batteries (incl.) into the thermo-hygrometer [J] respecting the polarity as
indicated inside the casing. Only use rechargeable batteries!
10.
To ensure DCF reception, immediately insert 3 x AA batteries into the receiver respecting the polarity. Refer
to the section Initialization below for more information on DCF. Note that the receiver is located inside the
thermo-hygrometer
11.
Slide the thermo-hygrometer [J] into the shelter [I].
12.
Place the thermo-hygrometer [J] on top of the second side support [F] and secure it with a screw.
13.
It is strongly recommended to test the station before mounting it outdoors.
14.
Wait for the two stations to synchronize. This synchronisation may take a couple of minutes. Do not touch
any button during synchronisation. Once the synchronisation finishes, make sure that all components work
properly.
