VTSS100_v3
VELLEMAN
3
3.
Set the temperature (± 300 ~ 350°C) and the airflow (1 ~ 3).
4.
Apply some solder paste onto the IC.
5.
Preheat the IC.
6.
Solder the IC onto the PCB by heating the lead frame evenly.
7.
Wash away the flux when soldering is completed.
NOTE: Be very careful not to damage the IC when soldering. Examine soldering conditions sufficiently.
DESOLDERING
1.
Connect the unit to the mains by means of the power cord and switch on the unit. Upon connection, the
automatic blowing function will start blowing air through the pipe. The heating element remains cool.
2.
Switch on your station. The heating element warms up.
3.
Set the temperature (± 300 ~ 350°C) and air flow (1 ~ 3).
4.
Melt the solder. Hold the gun in such way that the nozzle be directly over the IC. Be careful not to touch any
leads of the IC.
5.
Remove the IC using tweezers.
6.
Turn off the power to the unit.
4. Replacing the Heating Element
1.
Loosen the two screws and slide out the heating element. Be careful not to drop the quartz glass or the
heating element.
2.
Disconnect the terminal and remove the heating element.
3.
Insert a new heating element and reconnect the terminal. Reconnect the ground wire. Handle the heating
element with great care.
4.
Reassemble the handle.
5. Technical Specifications
Power Supply
230VAC / 50Hz
Dimensions Station
188 x 127 x 2446mm
Total Weight
3.8kg
Power Consumption
250W
Temperature Range
100°C ~ 500°C
Air Capacity
23l/min
Heating Element
metal heating core
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
CAUTION: Disconnect the unit from the mains prior to examining and maintaining. Failure to
do so may result in electroshocks.
