MICRO
SMALL,
MEDIUM
& LARGE
1 2
2.0.3. ASSEMBLY AND REPLACEMENT OF SPRINGS (MICRO)
Lift the upper part of the gait trainer (see section 2.0.1.). The
springs can now be mounted/replaced.
2.0.4. HEIGHT ADJUSTMENT
Loosen the handles on both sides and adjust the frame to the
desired height. It is important that the height is adjusted equally
on both sides of the frame. Tighten the handles again on both
sides.
Note:
Never perform height adjustment while the gait
trainer is in use.
2.0.2. ASSEMBLY AND REPLACEMENT OF SPRINGS
Release the tilt bar and raise it to the upper position so the
lower risers appear in front of the rear wheels. Push and turn
the black plug at the bottom to remove it, so the springs will
appear. Fit/replace the spring and slide the plug up into the
groove and turn in place until it locks.
2.0. USER MANUAL
2.0.1. ASSEMBLY OF UPPER PART AND BASE
The upper part is placed in the risers on the chassis. The upper
part is lowered into place in the two risers.
Note:
The handle must face the swivel front wheels.
