6
CineView HD Pro Decoder Installation and User Guide
Hardware Installation
Hardware Installation
CineView HD Pro Decoder Board Installation
1. Power off the PC, unplug it from the AC source, and remove the cover to
expose the chassis and motherboard. It is important that the CineView HD Pro
decoder board be plugged into a PCI bus master slot, making sure the edge
connectors are fully engaged. Secure the board’s mounting bracket to the PC
chassis. Connect the video cables and the genlock cable to the appropriate BNC
connectors on the board. Connect the supplied audio/video breakout cable (Vela
part no. 6000-0187) to the board’s DVI connector. See Figure 1-18 for an assem-
bly view of the breakout cable, and Figure 1-19 for cable pinouts.
2. Connect other cables as desired or applicable. Refer to the CineView HD Pro
board layout drawings at the end of this chapter if necessary.
CineView HD Pro Jumpers and Headers
The following jumpers and header connectors can be found on the CineView HD
Pro decoder board. Refer to Figure 1-16 or Figure 1-17 for locations.
• J2, J3 — RS-422 null modem select jumper blocks. See Figure 1-16, page
26, for jumper settings.
• J4 — RS-422 header. See Table 1-2 for pinouts.
• J8 — Config Header. General purpose shunts for debug.
Hazardous electrical voltages may be present in your computer
when its cover is removed for installation of this decoder. Follow
proper safety procedures during installation. Remove all power
from the computer before installing the decoder board.
WARNING!
STATIC DISCHARGE CAUTION
To avoid damage to the decoder from static discharge, keep the board in its
protective bag until ready to be installed. Use an antistatic strap at all times
when handling the decoder board during installation. Avoid touching com-
ponents and edge connectors.