Single unit (re-)placement
1
2
4
5
6
7
10
1 Disconnect the mains before operating the
linear lighting system.
Note
: Type of unit
and/or profile may vary.
2 Make sure poles and wiring are in correct
position.
3 Insert connector to the flatcable.
4 Press and mount the fallout safety clip into-
9
In case of a sports or emergency unit, place
extra safety clips onto the unit- and profile,
5 on either side
of the unit, equally devided.
10
Caution
: Bracket may contain sharp edges.
11
Caution
: Make sure wiring doesn't get stuck
between the unit and the profile and
is
placed
properly inside the linear lighting system.
- the profile.
5 Press the unit into the profile.
6 Mount the sealing and pressure plate(s)
onto the bracket.
7 Tighten the
s
crew(s).
8 Mount the locking clips (6x)
,
3 on each side
of a single unit or blindplate.
IP65
11
8
9
3
9/16
Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Single unit (re-) placement