Sensor MD-L-*-VSS Configuration
IP65
When the Veko Advanced Relay sensor is plugged into the light line and connected to power, it will fully function and perform as a motion
detection sensor. All Veko sensors have a standard configuration. Some of these features are manual adjustable with a remote control (TR67).
These functions are described in the manual below. You can use this manual on site when a re-configuration is needed, a maintenance test is
required, or the lights need to be manually overruled.
1 Sensitivity detection*
The sensitivity of the
movement detection can
be adjusted according to
your preferences.
2 Sensitivity twilight
mode*
The sensitivity of switch-
on relative to the
available daylight can
be adjusted.
3 Check the programmed
setting
*
of:
3.1 Detection accuracy
3.2
Sensitivity
twilight
mode
4 Red LED Setting
The red LED flashes when
detected. This can be turn-
ed off or on.
It's recommended to turn
the red LED off, to prevent
influence on the twilight-
mode sensitivity.
Fast
Blink
Fast
Blink
Fast
Blink
Fast
Blink
Solid
Solid
3 flashes / colour
3 flashes / colour
1x
1x
1x
1x
1= Low Sensitivity
...
5= High Sensitivity
1= 100 Lux
...
9= 900 Lux
Flashes red colour X times for set Lux level.
Flashes green colour X times for set detection
sensitivity.
Save
Save
Cancel
Cancel
Hold until
light responds
Hold until
light responds
Hold until
light
responds
Hold until
light
responds
Hold until
light
responds
3 flashes / colour
Red LED detection flash is turned off or on
* Automatically returns to normal mode, if there is no activity for 20 seconds. Settings will be saved.
12/16
Manual Veko linear lighting system / IP65 / V04 / 2020-09-29 / Sensor configuration