R404-1
16. Press “START/OFF” to leave configuration mode and return to standby
mode.
17. The configuration can also be done through “CPAP” PC application.
Connect the device and your PC with a USB cable, then run “CPAP”
software on your PC, this software allows you to do most of the
configurations on PC. When the device is connected to PC, it enters
USB mode. The pressure output will be stopped and the device will
display “USB” on the screen. Disconnect the USB cable, the device goes
back to Standby mode.
VI Cleaning and Sterilization
It is recommended that the air tube and mask be thoroughly cleaned with hot
water after each use and cleaned with a mild detergent after the last treatment of
the day. If your physician or respiratory therapist specifies a different cleaning
procedure, follow their instructions.
Rinsing (after each treatment)
1. Disconnect the air tube and mask.
2. Rinse the mouthpiece and mask with water.
3. Dry them with clean soft towel or let it air dry.
4. Reassemble the product when completely dry and put these parts in a dry,
Summary of Contents for CP-03
Page 3: ...R404 1 B Assemblies...