Network Type
: Select PDH/DSn as the network type.
High Rate
: Options are 1.5Mbit/s, 2Mbit/s, 34Mbit/s and 45Mbit/s.
Dual
: Dual DS1or E1 Receiver Option ON/OFF ; the Receiver 2 set exact same configuration as Receiver 1.
7.3.2 Rx Setup > Interface
Tapping the Interface box opens the Rx Interface Setup screen shown below.
TEST PORT :
If a PDH/DSn structure has been selected in the Hierarchy setup, the optical options will be disabled under the
test port menu.
TERMINATION:
The sensitivity of the receiver can be set for ITU-T and ANSI, Protected Monitoring Points (PMP) or High
Impedance connections. The options under the termination menu are as follows:
-
Terminated:
The received signal is terminated with a 75 ohm or 100 ohm (120ohm in E1) impedance enabling the unit to
decode the signal over a wide range of cable losses.
TX150 e-Manual D07-00-023 Rev A02
Page 17 of 107
