33
Applying Power to System
Cold Boot
On initial power up or after upgrading system software, you must reset the system with a RAM clear/cold boot to
ensure that the Flash/RAM is cleared completely.
1.
Turn the power to the console Off. Locate the RAM Clear jumper J2 on the CPU board (Item 5 in Figure 6 on
page 12). Figure 24 shows the RAM Clear jumper in the Operating position and in the RAM Clear position.
Figure 24. RAM Clear Jumper Positions
2.
Move the jumper down to the RAM Clear position (pins 1&2). Turn the power to the console ‘On’ and wait until
the console completely boots up.
3.
As the console boots up it will perform a series of tests and display the messages below:
Test Passed Message
Test Failed Message
Action (If Failed)
RAM TEST - OK
RAM FAIL
Replace CPU board
ROM TEST - OK
ROM FAIL
Replace CPU board
COLD BOOT
NVRAM TEST - OK
NVRAM FAIL
Replace CPU board
STARTUP COMPLETE
4.
You see the ‘No Tanks Configured’ message (see Figure 25) following the successful completion of the self
tests. After approximately 2 seconds the console will automatically reboot.
5.
When the ‘No Tanks Configured’ message is visible the second time, turn the power to the console ‘Off’.
6.
Move the jumper up to the Operating position (pins 2&3).
7.
If you have not done so already, peel away the protective film from the display’s touch screen. Close the front
panel of the console.
8.
Turn the power to the console ‘On’. Once again the system will cold boot and display the ‘No Tanks
Configured’ message as shown in Figure 25.
9.
Go to the Setup and Operation manual to program the console.
OFF
J2
3
2
1
J2
J2
con
s
ole
s
/tl
s
2/r
a
m.ep
s
Operating Position
(jumper on pins 2&3)
Pins
RAM Clear Position
(jumper on pins 1&2)
