Veeder-Root TLS-450PLUS, Operator'S Manual

Page: 18 / 69

Initial Setup Of The Console Using Workflow Wizard Setup>Communication>Internal Modem
14
Setup>Communication>Internal Modem
This screen lets you configure the internal m ode m (TLS-450PLUS consoles only) which is used
for data collection (Note: in the above exa m ple screen no internal m ode m is installed).
Serial Command Security
Select Enable to require all inco m ing serial co mm ands to
have a security code.
Security Code
[Field available and required if Serial Co mm and Security
field is enabled].
This the security code that all serial co mm ands m ust have
to be accepted by the console. Valid security codes m ust be
exactly 6 digits (0 - 9) long.
RS232 End of Message
Enables or disables the End of Message RS232 protocol.
This protocol is used by third party devices that m ay want
to interrogate the console for inventory or other related
data. These devices require an End-Of-Text co
mm and that
signals to the device when the co mm unication string fro m
the console ends.
Please refer to the custo m er's third party device for the
type of code to enter in the ETX Characters Display and ETX
Characters co
m puter fields below.
ETX Characters Display
[Field enabled only if RSR 232 End of Message field is
enabled]
End-Of-Text (ETX) character. ETX is progra mm able if
enabled via the S53100f co mm and. If it is disabled, the ETX
is a fixed Control-C character (ASCII 03).
ETX Characters Computer
[Field enabled only if RSR 232 End of Message field is
enabled]
End-Of-Text (ETX) character. ETX is progra mm able if
enabled via the S53100f co mm and. If it is disabled, the ETX
is a fixed Control-C character (ASCII 03).
Configured
Deter m ines if the internal m ode m is enabled or disabled.
Label
Na m e of the internal m ode m .
Baud Rate
Choices are: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200. The default is
9600.
Byte Size/Data Bits
Choices are: 8 or 7
Parity
Choices are: Odd Parity, Even Parity, or None
Stop Bits
Choices are: 1 or 2
Use Handshaking
Choice is: No Handshaking
Modem Dial Type
Choices are: Tone or Pulse
Dial Tone Interval
Choose interval to wait if there is no dial tone: Fro m 0001 to 9999 hours
Answer On
Choose answer on the nu m ber of rings selected: Fro m 0 to 9
Dial In Config
Advanced setting. Leave blank unless directed by Support.
Dial Out Config
Advanced setting. Leave blank unless directed by Support.