TCP/IP Module IP Address/Configuration Using Telnet
Entering the TCP/IP Interface Module’s IP Address
22
After saving your Telnet menu setup settings for the TCP/IP Interface Module, the module can be tested to confirm
communication is working.
1. At the DOS command prompt type:
Telnet y.y.y.y 10001
(where y.y.y.y is the IP address of the TCP/IP Interface Module and 10001 is the port number. Make sure you
enter spaces as shown)
2. Press
Enter
. A blank screen will appear.
3. Type:
<ctrl+A>200
4. Press
Enter.
The console’s inventory will appear – this confirms good communication between the laptop and
console.
AFTER NETWORK SETUP OF THE TCP/IP MODULE
When using an ethernet crossover cable to configure the TCP/IP Interface Module, and programming is
completed, connect the console to the network.