background image

Displayed Alarm Messages

5

Mag Sensor High Liquid 
Alarm

MS, s

Monitored parameter exceeded preset threshold.

Call for service following the procedures 
established for your site.

Mag Sensor High Liquid 
Warning

MS, s

Monitored parameter exceeded preset threshold.

Call for service following the procedures 
established for your site.

Mag Sensor Install Alarm

MS, s

Sensor not installed in correct position.

Call for service following the procedures 
established for your site.

Mag Sensor Low Liquid 
Alarm

MS, s

Monitored parameter exceeded preset threshold.

Call for service following the procedures 
established for your site.

Mag Sensor Low Liquid 
Warning

MS, s

Monitored parameter exceeded preset threshold.

Call for service following the procedures 
established for your site.

Mag Sensor Temperature 
Warning

MS, s

Ambient temperature exceeded sensor’s operat-
ing range (-40 to +122°F [-40 to +50°C]).

Warning removed when temperature returns 
to within sensor’s operating range.

Mag Sensor Water Alarm

MS, s

Monitored parameter exceeded preset threshold.

Call for service following the procedures 
established for your site.

Mag Sensor Water Warn-
ing

MS, s

Monitored parameter exceeded preset threshold.

Call for service following the procedures 
established for your site.

Maximum Product Alarm

T

Product level rose above the programmed limit.

Stop delivery. Do not allow additional deliv-
ery until product drops below preset limit.

Missing Delivery Ticket 
Warning

T

Delivery Ticket information has not been entered 
at the console.

Enter Delivery Ticket information. 

No Dial Tone Alarm

(TLS4/TLS-450PLUS only)

Co

System failed to detect an operational line after 3 
tries.

This alarm must stay active until it is con-
firmed that the alarm has been reported.

No CSLD Idle Time Warn-
ing

T

System has not had enough idle time over previ-
ous 24 hours to run a statistical leak detection 
test.

Stop dispensing fuel from this tank until 
CSLD test is complete.

Overfill Alarm

T

Fuel level has exceeded a programmed limit. 
Potential overflow of tank may occur.

Stop delivery. Check for spillage.

Printer Out Of Paper

(TLS4/TLS-450PLUS only)

Paper roll is empty.

Replace the paper roll only with Veeder-Root 
supplied paper rolls:
P/N 514100-456 - TLS-4/450PLUS
P/N 514100-210 - TLS-3XX

Printer Out Of Paper

(TLS-3XX only)

System

Periodic Test Fail Alarm

Q

0.2 gph (0.76 lph) test failure. Dispensing halts, if 
programmed to do so.

Consult PLLD Alarm Quick Help Guide and 
PLLD diagnostic screens.

Periodic Test Needed 
Alarm

Q, T

A periodic in-tank leak (0.2 gph [0.76 lph]) test 
has not been successfully completed within the 
programmed number of days.

Schedule a 0.2 gph (0.76 lph) test.

Periodic Test Needed 
Warning

Q, T

A periodic in-tank leak (0.2 gph [0.76 lph]) test 
has not been successfully completed within the 
programmed number of days.

Schedule a 0.2 gph (0.76 lph) test.

Periodic Leak Test Fail 
Alarm

T

In-tank leak (0.2 gph [0.76 lph]) test failed. Dis-
pensing halts if programmed to do so.

Rerun in-tank leak test. If second test fails, 
call for service.

Messa

g

e

Short 

Device ID

Cause

Action

Summary of Contents for TLS-3 Series










Reviews: