Appendix B
Datalogger Site Connection and Initialization
B-8
Figure B-8. TDIM Setup
11. Select the “System Setup” page and type in the Host name and then click the “Save” button (see example in
Figure B-9). It is recommended that you use the network name assigned by the network administrator or some
other name that identifies the location. While on this page click the Diagnostic Page link (bottom Left).
Figure B-9. Entering Host name
12. In the “Diagnostics” page (lower left in above figure), click on “DIM Communications” to verify that the DIM
communications are successfully being recorded by the Datalogger. Any transactions occurring after the
Datalogger was configured will be shown on the screen (see example in Figure B-10).
Select
Select
Enter label
Select DIM Protocol
Enter desired units
Select True
Accept default unless there is a conflict
TDIM (ETH1)
First select
System Setup
Page
Click on
host name
to open this
page
Enter Host name
(e.g., Site Name)
After saving the “Hostname” entry, click on the “Diagnostics” link
to verify DIM communications
