Page 7
4.0 – Trap Bungee
The forward trap bungee has already
been installed in the forward cross bar.
Remove the bungee from the
packaging and slide the bungee
through the black grommet located on
the hull near the side stay attachment.
Then feed the line through the nearest
tramp grommet, under the tramp and
back up the opposite side. Fix the
ends with the ball stops and hog rings
in identical fashion to the forward set
up. (Figure 4.A)
5.0 – Mast Rotation
Find the 5/32” line labeled “Mast
Rotation”. Feed this line through the
cleat located on the hull just aft of the
front cross bar, and then under the
tramp. Bring the line back up through
the tramp at the grommet located in the center of the tramp just aft of the storage
pocket. Run this line through the turning block provided and back through the center
grommet, under the tramp and back up through the cleat on the opposite hull. Note:
the turning block will be attached to the line run through the mast rotation arm on the
mast after the mast is stepped to control rotation.
6.0 – Mast Assembly
6.1 - Spreaders:
Attach the
spreader arms to the fittings
located approximately ½ way up
the mast. Use the barrel nut to
adjust the rake of the spreaders
such that they are equally
positioned and a straight edge
placed between them will
provide a gap of at least 1 ½”
measured between it and the
mast. Adjust the extensions
and rake of the spreaders so
that they measure
approximately 27 ½” tip to tip,
and 1 ½” of rake. Note: these
measurements are made from
the location of the wire, and not
the end of the retention clips on
the spreaders. Make sure both are set at the same angle, as failure to do so may put
a permanent twist in the mast.
Fig 4.A
Fig 6.A
