Page 16
11.0 - Boom
Attach the end of the boom
gooseneck assembly to the mast
bracket with the 1 ½” rigging pin.
12.0 - Mast Rotation
Connect the single 20mm block,
which is already attached to the
rotation line coming through the
center of the tramp, to the end of
the mast rotation arm with a bow
shackle or short piece of line
depending on the style of arm fitted
on your boat.
With the approximately 2’
long piece of 4mm line tie
the end of the mast rotator
arm to the eyelet mounted
on the lower boom face.
When complete the rotation
arm should be set
approximately parallel to
the tramp as to adequately
clear the storage pocket.
13.0 – Mainsail
Roll out the mains sail on a clean
flat surface. Insert the battens
into the appropriate pockets.
Make sure they are inserted fully,
and lie flat to allow them to go all
the way into the cap sleeves on
the sail luff. Tie each batten in
place. Fold the batten tie line in
half and loop through the
grommet on 1 side of the sail.
Lead both lines then through the
hole in the batten and then
Fig 11.A
Fig 12.A
Fig 13.A
