Charger and Pillar Light Connections
Charger and Pillar Light Connections
Page 44
Use this procedure to accurately determine the gate opening angle:
The following protection fuses are provided on the system:
Determine Gate Swing Angle
Determine Gate Swing Angle
USE GATE SWING ANGLE OF
90 Degrees
100 Degrees
110 Degrees
120 Degrees
60 Degrees
70 Degrees
80 Degrees
1 351mm
1 474mm
1 587mm
1 687mm
1 000mm
VALUE Z FROM...
1 075mm
1 218mm
1 587mm
1 687mm
1 732mm
1 075mm
...TO
1 218mm
1 351mm
1 475mm
Step 3
1m
Open the gate and measure a
distance along the gate a
distance of 1m from the
centreline of the gate hinge.
Make a mark on the ground.
Measure the distance on the
ground between the two marks
(Z). Using this Z value, read off
the gate opening angle from the
table below.
Step 2
1m
Close the gate and measure a distance
of 1m from the centreline of the gate hinge.
Make a mark on the ground.
Step 1
Page 45
Fuse Protection
Item
MAIN CONTROLLER
Motor Circuit - fuse per channel
Light circuit
Auxiliary supply
CHARGER
Mains input
Type
Automotive Fuse (25X7)
5X20mm
Electronic fuse - not replaceable
5X20mm
Rating
15A
3A Fast Blow
3A
250mA Fast Blow
S Sens1
S Sens2
M Sens1
M Sens2
Light
Light
Batt +
Batt -
MTR M+
MTR M -
MTR S+
MTR S -
Sens+
Sens-
Safe CLS
Safe OPN
Com
LCK/STP
TRG
PED
Com
FRX
LIT
LED
Com
Aux 12V
Safe Com
Sol
220V AC
Mains in
E
N
L
Protection fuse on
mains input to
charger (rating:
250mA slow blow)
Auxiliary supply
Pillar
light
NEUTRAL
LIVE
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
N
L
E
Figure 12 Charger and pillar light connections
Table 3 Fuse schedule
To reset : Power off controller for at least 1 minute and re-apply power.
