background image

6

AC Recharge Port

Located just below the 12 volt DC outlet, the AC port is also covered by a rubber cap. The AC

recharge adapter’s barrel connector plugs into this port during recharge.

LED Area Light

Located on the center of the control panel, this twin LED area light will provide proper lighting

while changing a tire or connecting the Compact Elite™ to a battery.  This area light is efficient

and will continuously operate for (50) hours with a fully charged battery.  The area light is

activated by the On/Off switch located on the lower right side of the control panel.

1.  ON/OFF Safety Power Switch (no key required, no key to get lost!).

2.  Cordless/rechargeable, includes AC and DC charging adapters

3.  Includes non-spillable, maintenance-free, heavy duty, 9 amp hour, sealed,

lead-acid battery.

4.  Requires no maintenance (other than recharging) for optimum operation.

5.  Heavy duty, industrial grade copper clamps, and #6AWG jumper cables with 

exclusive recessed cable holsters.

6.  Exclusive cable storage channels that keep jumper cables out of the way until 

they are needed. 

7.  110 volt AC charger is Underwriter Laboratories safety tested and listed.

8.  Easy-to-read LED battery charge status display - activated by pressing the 

charge status button and automatically activated during AC recharge.

Refer to Sections 4.1 and 4.2 for use of AC recharge adapter and DC/DC charging adapter.

1.2

START-IT COMPACT ELITE APPLICATIONS

-

Jump-start

Most batteries of engines with a standard 12 volt DC battery system: boat, 

small truck, car, airplane, RV, personal watercraft, snowmobile, tractor, etc. 

-

Operate

(using 12 amp rated 12 volt accessory outlet): 12 volt DC fans, fluorescent 

worklights, air compressors, spotlights, TVs, portable radios, cassette or CD players, and 

more. The unit can quick-charge a cellular phone by using the phone’s 12 volt DC 

adapter cord. 

-

Illuminate areas 

under the hood, inside tents and work areas while changing tires, etc. 

NOTE:

Other Vector appliances may also be used with this Compact Elite Jump-tarter, as long

as they do not  exceed the 12 amp limit of the jump-starter’s 12 volt DC outlet. 

READ INSTRUCTION MANUAL AND PRODUCT LABELING CAREFULLY, BEFORE USING THIS

PRODUCT. FOLLOW RECOMMENDED WARNINGS, CAUTIONS, AND SAFETY PROCEDURES,

AND MANUFACTURER’S GUIDELINES FOR YOUR VEHICLE BATTERY.

IMPORTANT 

This unit is delivered in a partially charged state - you must fully charge it before using 
it  for the first time. Initial AC charge should be for 24 hours.

Summary of Contents for START-IT













Reviews: