Page 5
Cleaning and Maintenance
WARNING: The unit uses a 230V supply and contains rotating mechanical parts.
• Before carrying out any maintenance or cleaning operations the mains electrical supply MUST be disconnected
.
The air filters and heat exchanger of the Vectaire EVO220 should be cleaned regularly by a suitably qualified person (the
frequency of cleaning will vary depending on the installation environment). Filters should be replaced after a maximum of 3
cleaning cycles.
Filters:
•
Remove the filter covers on the main panel.
•
Slide out the filters by pulling out the tabs
•
Clean the filters carefully using a vacuum cleaner, replace in the slots and refit the filter covers
Heat Exchanger:
•
Firstly remove filters as described above
•
Remove the screws securing the main panel and carefully lift off. Using the plastic strap fitted, carefully pull out the heat
exchanger
•
Caution: if this is done during cold weather, the heat exchanger may contain water. It is advisable to have a plastic bowl
available to avoid spillage.
•
Lightly clean the faces of the heat exchanger with a vacuum cleaner. Replace the heat exchanger carefully by sliding the
assembly back into the cabinet.
•
Replace the front cover by securing in place using the screws.
•
Finally, replace the filters as above.
Never use water or any other fluids to clean the heat exchanger.
•
Return the heat exchanger and filters to their original position.
•
Power to the unit can now be restored.
Filter Replacement
Filters should be replaced annually or after a maximum of 3 cleaning cycles.
Replacement filters are available from Vectaire - call us on +44 (0) 1494 522333 or via [email protected]
EVO220DC/lcd.021220
E & O.E
Vectaire Ltd, Lincoln Road, Cressex Business Park, High Wycombe, Buckinghamshire, HP12 3RH
Tel: +44 (0)1494 522333. Fax: +44 (0)1494 522337. Email: [email protected]
