57
©Vecow MTC-6000 User Manual
GETTING TO KNOW YOUR MTC-6000
2.5 Main Board Jumper & Deep Switch Settings
2.5.1 Top View of MTC-6000 With Jumper and Deep Switch
The figure below is the top view of MTC-6000 board, and it shows the location
of the jumpers and the switches.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, please connect the
pins with the clip. To "open" a jumper, please remove the clip. Sometimes a
jumper will have three pins, labeled 1, 2, and 3. In this case you would connect
either pins 1 and 2, or 2 and 3.
You may configure your card to match the needs of your application by DIP
switch as shown below (the deep switch on and off)
CN13
CN12
JP6
JP5
JP3
JP2
JP4
JP7
JP8
JP9
Battery
CN11
CN14
J2
U19
J3
J4
CN31
CN32
CN33
CN30
CN16
CN15
JP10
J6
J7
J5
SW1
J1
JP14
JP11
JP12
JP13
CN10
JCOM3
JCOM4
JDIO2
JDIO1
J8
Closed
Closed 2-3
1
2
3
Open
1 : OFF
2 : OFF
ON
1
2
1 : ON
2 : OFF
ON
1
2
1 : ON
2 : ON
ON
1
2
