52
GETTING TO KNOW YOUR IVH-9000
©Vecow IVH-9000 User Manual
2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 5-pin
pluggable terminal block located in the back panel. It is below the general wiring
configuration.
For testing purpose, you can refer to the picture above to simulate ignition
signal input controlled by a latching switch.
Note:
1. DC power source and IGN share the same ground.
2. IVH-9000 supports 6V~78V wide range DC power input in ATX/AT mode.
In Ignition mode, the input voltage is fixed to 12V/24V/48V for car battery
scenario.
3. For proper ignition control, the power button setting should be “Power down”
mode.
In Windows, for
example, you need
to set “When I press
the power button” to
"Shut down."
Pin No.
Definition
1
External Power Button V+
2
External Power Button V-
3
Ignition (IGN)
4
External Power LED V-
5
External Power LED V+
IGN
IGN
V+
