Vecow ECX-3000 PEG, User Manual, Page: 79 / 159

71 ©Vecow ECX-3000 PEG User Manual GETTING TO KNOW YOUR ECX-3000 PEG
2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin
pluggable terminal block locates in the back panel. Please find below the
general wiring configuration.
For testing purpose, you can refer to the picture blow to simulate ignition signal
input controlled by a latching switch.
Note :
1. DC power source and IGN share the same ground.
2. ECX-3000 PEG supports 12V to 50V wide range DC power input in ATX/AT
mode. In Ignition mode, the input voltage is fixed to 12V/24V for car battery
scenario.
3. For proper ignition control, the power button setting should be "Power Down" mode.
In Windows for example,
you need to set "When I
press the power button" to
Shut down.
Pin No. Definition
1 Ignition
2 SW+
3 SW-
V+ V
DC-IN