![background image](http://html1.mh-extra.com/html/vdo/ms-5200/ms-5200_owners-manual_3739157035.webp)
Dynamic route
You can set the following parameters for the dynamic route planning:
❑
Re-routing level:
Use this setting to specify whether or not the navigation system
should plan a detour in the event of traffic obstructions. Five levels are available.
The lowest level (1) means that the direct route will go through the stationary
traffic depending on the conditions and the anticipated delay. If the highest level is
selected, an alternative route will be planned in most cases.
✎
Level 3 is a standard setting for dynamic route planning. It is the factory setting
(default).
❑
Traffic horizon:
This setting determines the radius in which the navigation system
should take traffic obstructions into account when planning your route.
❑
Entire delay:
Use this value to indicate the anticipated delay time due to a traffic
obstruction at or above which the navigation system should suggest that a new
route be planned.
✎
The anticipated delay is calculated on the basis of the data received from the TMC
station and may deviate from the actual situation.
❑
Automatic mode:
When this function is activated, the dynamic route planning
automatically guides you around traffic jams. There is no further query.
☞
Store the modified settings using “Return”.
☞
Press the
ESC
or the
4
button to exit the menu without changes.
Speed warning
Settings for the messages and warnings if the statutory or manual speed limits are
exceeded:
❑
Warning … over limit:
Setting for the tolerance value for exceeding the statutory
speed limits in the selected navigation database. When the set value is exceeded,
the speed display in the status line is displayed red.
✎
For this purpose, the speed display in the status line must be activated. See also the
“Screen config. –> Statusline” section.
✎
Availability of the legal speed limit depends on the selected navigation database
and on the relevant country.
A
WARNING: No responsibility is accepted for the correctness of the speed limit information
provided by the navigation system; it may not always reflect the currently valid regulations.
Always observe the applicable legal speed limits and traffic regulations. The vehicle
speedometer must always be given priority for display of the vehicle speed.
❑
Warn. at:
Setting of an absolute value for a speed warning. A warning is displayed
when this value is exceeded.
✎
This function is suitable e.g. in the case of a speed limit for winter tyres.
❑
P. sp. lim. warn. on/off:
Activates/deactivates an audible message for the speed
warning.
☞
Store the modified settings using “Return”.
☞
Press the
ESC
or the
4
button to exit the menu without changes.
Settings
34