10
* Depending on version
AUDIO ADJUSTMENT
ON/OFF
• Switch the set on or off :
You can use the set even when the car ignition
is switched off. See 'INSTALLATION'.
VOLUME
Please make sure you can still hear the traffic
(horns, sirens........)
• Adjust the volume :
SOUND
• Select one of the pre-defined sound styles:
– BASS-TRE : Your own settings of bass and
treble.
– FLAT : Mid-positions of bass and treble
– JAZZ: Jazz music
– VOCAL : Speech
– POP: Pop music
– CLASSIC : Classic music
– ROCK : Rock music
– These settings are memorised for each
source (Radio, Cassette/CD player* and CD
changer *).
SELECT
• Select the desired audio mode :
– BASS (low notes), TREBLE (high notes),
BALANCE (left-right), FADER (rear-front).
• Adjust the selected audio mode.
After 5 seconds the display goes back to the
last mode of operation.
LOUDNESS
This option dynamically amplifies the high and
low notes so as to improve the sound output at
low volume levels. See INITIAL SETTINGS option
'LOUD'.
MUTE (Silence) :
• Mute the set or cancel the mute :
The silent period may be interrupted by traffic
announcements (if TA/NEWS is switched on).
SOURCE
• Select the desired source :
- Radio
- Cassette/CD player*
- CD Changer * (if connected)
- Phone in (if connected) and if option is
selected in Initial Settings and a call is active.
Useful tips
Set does not function. No Display.
• Check fuse (set and car) and connections
Set functions but no sound?
• Adjust the volume of the set.
• Check fader and balance settings.
• Check aerial and its connection.
Set mutes when you drive or display shows 'TEL
CALL', but no car telephone is connected to the
set.
• See INITIAL SETTINGS; select Option 'TEL'
and set Choice to 'NO' .
Set mutes when you drive or display shows 'TEL
CALL', but the car telephone is not in used.
• See INITIAL SETTINGS; select Option
'PHONE' and set Choice to 'LO' or 'HI' according
to phone type.
Set mutes when you used the car telephone,
display shows 'TEL CALL', but you may still like
to listen to the radio.
• To restore the same volume level
Display shows 'TOO HOT' and the sound from
the speakers is reduced.
• A built-in safety circuit prevents the temperature
in the set from exceeding a certain level.
• Wait until 'TOO HOT' disappears from the
display before increasing the volume.
