VDO AcquaLink A2C59501997, Instruction Manual

Page: 27 / 54

Configure alarms from sensors
1. Press to access the main menu and then scroll and select ALARMS > Config alarms .
2. Scroll and select the alarm to be configured.
3. Scroll and select
Alarm below active / Alarm above active , then scroll and select Yes or No to
activate/deactivate the alarm.
4. To only activate the alarm, scroll and select Value , then set the threshold value.
5. To enable/disable the buzzer, scroll and select Buzzer , then scroll and select Yes or No .
6. Hold down to return to the data pages.
Configure alarms from NMEA 2000/SAE J1939 network
1. Press to access the main menu and then scroll and select ALARMS > Config alarms .
2. Scroll and select CAN then scroll and select the network: the managed alarm list appears.
3. Scroll and select the alarm to be configured.
4. Select
Alarm active .
5. Scroll and select Yes / No to enable/disable the alarm signal through the pop-up and the indicator light
on Nav Control.
6. To enable/disable the buzzer, scroll and select Buzzer , then scroll and select Yes or No .
7. Hold down to return to the data pages.
Menu description ALARMS
Alarm Description
Possible
values/commands
Default
Depth shallow Low water minimum threshold 0–9.9 m 2 m, buzzer
Yes
Depth navigation Maximum threshold. For example, a value near the
maximum value measurable by the sensor.
Safety depth minimum threshold 0 – 99.9 m
0 – 99.9 m 50 m, buzzer
No
5 m, buzzer No
Wind Wind speed maximum threshold 0 – 99.9 km/h 39.9 km/h,
buzzer No
Battery Battery voltage minimum threshold 0 – 32.9 V 10.8 V, buzzer
Yes
Alarm management
27 7” TFT display | Instruction manual v. 1.0 | © 2018 Continental Automotive Switzerland AG