Carbon Monoxide (CO) Gas Detectors
RCO-series
Ventilation Control Products Sweden AB
-
Phone: +46-31-811666
-
E-mail: [email protected]
-
Web: www.vcp.se
April 2020
Sensor probe handling
The wall mount version of the Detector is available with remote probe
The remote probe is connected to the main unit with shielded cable.
Default connection cable length is 3 m.
The sensor probes of all types are equipped with a hydrophobic microporous PTFE filter
to protect the sensor from dust, dirt and water drops.
The filter may be replaced if it gets strongly contaminated.
To replace the PTFE filter, unscrew the M25 nut and remove the old filter.
Place a new filter into the nut and tighten it again.
Dimensions remote sensor probe (option)
Note:
Protection IP65, shielded cable default cable lenght 3.0 m.
NB! Never stab or press the filter near its centre where the sensor is located since this may damage the sensor.
The recommended orientation of sensor probe is vertical with the sensor tip pointing downwards.
This prevents possible accumulation of condensed water on the sensor protection filter.
The horizontal orientation is also suitable.
Avoid upward position of the sensor tip.