WARRANTY
Vcomm Pty Ltd states that the warrant that the customer can rely on is that
provided by the manufacturer. In the event of any warranty claim please
contact us and we will forward it to the manufacturer. The manufacturer will
then determine the extent of their liability. This expressly negates, to the
extent possible by Australian law, any warranty reliance on Vcomm Pty Ltd.
ABN: 99 091 281 524
Vcomm Pty Ltd
www.resi-linx.com
7. If required, connect IR Target green connector directly into
Target Input H for local IR control of AV source.
8. (a) Refer Point 3. Connect IR Emitter (RL-IR700/800) to
corresponding IR Emitter Output ports either DISCRETE A / B
/ COMMON K or any combination required (as selected on
Receiver Module/s).
(b) Place the emitter head 10mm to either side of the IR
receiver on the AV source (depending on environmental
conditions). Single emitters (RL-IR700) or Double
Emitters (RL-IR800) can be used depending on installation
requirements.
9. Common IR output port for direct connection, using 3.5mm
to 3.5mm lead (included) to ‘Direct IR Input’ port on AV
device.
10. Connect the 12V DC 500mA power pack (included) to the
12V DC input I . Check the green PWR LED J is
illuminated.
IR LED indicators on both Receiver Module and Distribution
Module illuminate briefly upon receipt of IR commands.
NOTE: Some brands of TV/Monitors can reduce the
range of the IR Receiver head, which is outside the
scope of the warranty.
(refer to www.resi-linx.com for further information)
Distribution Module Connection (RL-IR305)
Discrete IR Selection
Direct IR output port
Troubleshooting
linx-IR Repeater System
Frequency Range
20-200kHz
Power Input RL-IR305
12V DC 500mA
- Switch Mode
Cable requirement
UTP
Maximum cable length per system
Up to 60 metres
Maximum Target reception distance Up to 10 metres
Maximum Targets per system
Up to 7 targets
by
RL-IR305 / RL-IR505
linx-IR Repeater System
resi-linx
Discrete IR System
®
¸
Patented