6. Additional Plasma Friendly Targets can be added into the
linx-IR Repeater System by:
(a) running UTP cable in looped configuration from one
RJ45 socket A on Receiver Module to another zone.
This can be repeated to link up to 7 Targets into the system,
depending on cable lengths and environmental conditions.
(b) using a linx-IR Distribution Hub (RL-IR170) to
allow for simple distribution to up to 7 Targets in a star
wired configuration, depending on cable lengths and
environmental conditions.
by
1. Connect the Plasma Friendly Flat IR Target (included) into
Target Input B on Receiver Module (RL-IR505).
2. Connect Receiver Module to Distribution Module (RL-IR305)
using UTP cable plugged into RJ45 connectors A and G
at both ends.
3. Each Receiver Module can select the IR Emitter output port
K on the Distribution Module that it wishes to control. IR
Discrete Selection Switch C on Receiver Module can be
switched to the ‘ON’ position for either DISCRETE A / B /
COMMON or any combination required (including all ON).
These switches correlate to the same IR Emitter Output
Ports K of the Distribution Module. Factory setting is set
to ‘COMMON’.
4. If required, connect either Single or Doub
le IR Emitter (RL-
IR700/800) to the IR Emitter Port E on Receiver Module
for control of local AV source.
5. Discrete IR facility specifically for use with res-linx AV
Matrix System
. Please refer to AV Matrix System installation
instructions for more details.
INSTALLATION MANUAL
Receiver Module Connection (RL-IR505)
WARRANTY
Vcomm Pty Ltd states that the warrant that the customer can rely on is that
provided by the manufacturer. In the event of any warranty claim please
contact us and we will forward it to the manufacturer. The manufacturer will
then determine the extent of their liability. This expressly negates, to the
extent possible by Australian law, any warranty reliance on Vcomm Pty Ltd.
ABN: 99 091 281 524
Vcomm Pty Ltd
www.resi-linx.com
Patented
RL-IR305 / RL-IR505
linx-IR Repeater System
resi-linx
Discrete IR System
Discrete IR Selection
G RJ45 socket
H Target Input
I 12V DC Input
J IR/PWR LEDs
K IR Emitter ports
®
¸
Local IR Emitter Port
IR Line Out
Additional IR Zones
IR Zone 1
UTP cable
Flat IR Target
RL-IR505
Receiver Module
Remote
Control
RL-IR305
Distribution Module
Remote
Control
To additional IR
zones if required
IR Zone 2
RL-IR505
B
C
E D
I
A
G
F
RL-IR305
A RJ45 sockets
B Target Input
C Discrete IR Selection switch
D IR Line Out
E Local IR Emitter port
F IR/PWR LEDs
K
J
H
®
