29
Operating
the LCD Display
GENERAL SETTING
Turning the ebike ON/OFF - Hold the mode button until the display turns ON
Press and hold M to power on. In the on state, when the bicycle is stationary, press and hold
the UP and DOWN buttons simultaneously for more than 2 seconds, the display will enter the general
setting state.
M
Increase Pedal Assist Level - Press up arrow button
Decrease Pedal Assist Level - Press down arrow button
Turn ON/OFF front /rear Lights - Short press the headlight key to turn ON the headlight and
taillight, repeat to turn the lights OFF.
After the display is turned on, the display shows the real-time speed and total mileage (km)
by default. Short press " i " key, the displayed information can be in real time speed (km/h),
single mileage (km), total mileage (km), maximum speed (km / hour), average speed
(km / Hour) and cycling power.
I
When the ebike has not been used for 10 consecutive minutes the display will automatically
shut down. The pedal assist and throttle features will no longer work when the display is
turned OFF.
www.vbike.ca
vBike Canada
Ensure you do not change settings that are not listed in the above table.
Changing other settings may cause your ebike to stop working properly and
void your warranty.
Attention
Setting Function Default Explanation
Function
Single mileage reset
Backlight brightness
Imperial and
Metric Unit Conversion
Explanation
Screen View
TC stands for Clear Single Mileage. Press the UP / DOWN button to select Y / N. Y (Yes)
means to clear the mileage of a single trip. N (No) means that the mileage of a single trip
is not cleared. Press "i"key to confirm and enter the backlight brightness setting state.
bL stands for backlight. You can set the parameters 1, 2, and 3 to indicate the backlight
brightness, 1 is the darkest, 2 is the standard brightness, and 3 is the brightest. The default
value of the display is 1. You can change the backlight brightness parameter by pressing
the UP / DOWN button. Press the "i" key to confirm and enter the metric and English unit
conversion setting state. Press and hold the "i" key to confirm and exit the general setting
state.
U stands for the unit, 1 is the English system, and 2 is the metric system. The speed and
mileage units can be changed by pressing the UP / DOWN button. Press the "i" key to
confirm, press and hold the "i" key to confirm and exit the normal setting state. The
display's default unit is metric.
