Vax VX23 Series, User Manual

Page: 7 / 16

Using your machine
Twist the detergent cap
anti-clockwise and lift
to remove
Before replacing the twin
tank make sure the hard
water filter is in place
Align the twin tank and push
until it clicks into place
Pour 50ml of Vax
detergent and 250ml of
water into the detergent
tank then replace cap and
twist clockwise to tighten
Filling twin tank
Before you begin cleaning Before you begin cleaning
• The steam mop and accessories get very hot during use, always allow them to cool down before handling.
• Always unplug and switch off the steam mop when assembling and filling water and solution tank.
• Always switch off the steam mop before emptying the water tank or changing the cleaning pads/accessories.
•
IMPORTANT: Please refer to floor manufacturer’s care recommendations before use and test the steam mop
on a discrete area of flooring to begin with.
• When using the steam mop, basic safety precautions should always be observed.
• Don’t aim the steam mop at people, animals, plants and electrical components such as interior of ovens or wires. Never touch the
steam burst or floor head from a short distance. (There is a risk of scalding)
• The steam mop is equipped with a thermostat and a thermal cut-out. If for any reason the steam mop overheats it
will switch off. If this happens turn off and unplug the steam mop, allow to cool for a least 2 to 4 hours and re-start.
Plug into mains and slide
switch to on position. The red
light will illuminate to show
power on. The blue light will
illuminate to show the steam
mop is ready to use
To use with detergent select
desired setting for the area
you want to clean. These
settings are
tile
or
vinyl
min
max
DETE
RG
EN
T
off
min
DE
TE
RG
ENT max
To recline the steam mop
place your foot onto the
floor head and pull
handle backwards
To steam your floors
without
solution select
carpet
or
wood
setting
Using your machine