Using your machine
Using your machine
Make sure water supply
is not connected. Firmly
push the water hose pipe
with suitable connector
onto the water inlet
to lock into position.
Connect water hose
pipe to a suitable
water supply and
turn water on.
Before plugging the
machine in, press the
unlock safety button
on the trigger handle
and squeeze the trigger
until water starts to flow
through the nozzle.
CAUTION:
Always use an RCD (Residual Current Device) adaptor when using this pressure washer.
CAUTION:
Don’t leave the pressure washer running when not in use, or for more than 5 minutes to prevent overheating.
Connect the power
cord to the mains
supply via an
RCD adaptor.
Push the ‘I’ switch to
turn on. The machine
will run for a few seconds
then stop but no water
will be released.
Squeeze the trigger on the trigger handle to release
a high pressured water jet, and start cleaning.
Push ‘O’ switch to turn off.
Don’t aim the pressure
washer directly at
people, animals, plants,
electrical components,
wires or the pressure
washer itself.
Before switching the machine on, the trigger handle must be squeezed to release water and to remove any airlocks in the
machine or pressure hose. Always release any build up pressure in the handle prior to disconnecting the hose.
CAUTION
Whilst firmly pushing the lance
into the trigger handle turn
clockwise to lock into position.
To remove the lance from the
trigger handle firmly push and
twist the lance anti-clockwise.
When unlocked pull to remove.
