12
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
Place handle in low position and
turn cleaner over so bottom
side is facing up.
Remove the 6 screws
as shown with a Phillips
screwdriver.
Lift off bottom plate.
Remove used belt (
A
) from large
pulley (
B
) and discard.
With lettering on outside of belt, slide new belt
over motor shaft (
A
).
Place other end of belt over large pulley (
B
) while
rolling the pulley in direction shown.
Turn agitator brush roll making sure belt turns
freely and is not pinched between agitator brush
roll and agitator shield.
Reposition bottom plate and 6 Phillips head
screws. Tighten screws securely.
Maintenance
Belts
Disconnect cleaner from electrical outlet.
The belts are located under the bottom plate of the cleaner and should be checked from time to time to be sure they are
in good condition.
Replacing Flat Belt
Replace belt if it is stretched, cut or broken. To check the fl at belt, refer below.
Removing Bottom Plate
Removing Belt
Positioning Belt
WARNING:
Agitator brush roll can start suddenly. Unplug cleaner before turning it over.
A
A
B
B
V-Belt: What to buy
Use only genuine VAX belts with your cleaner
