(*NOTE: 50ml detergent plus 200ml
water to 1 clean water tank).
Operation
Before you begin cleaning
Filling detergent tank
Filling clean water tank
vax.co.uk
5
Remove the clean
water/detergent tank at
the front of the unit.
Twist the detergent cap
slightly anti-clockwise
to remove.
Pour 50ml of Vax detergent
and 200ml of water into the
detergent tank and replace
the tank cap. Tighten by
twisting clockwise.*
Slide the water/detergent
tank down and snap into
place.
IMPORTANT:
Do not use hot or boiling water to fill clean water tank. Do not overfill the water tank.
IMPORTANT:
Do not mix Vax detergent with any other cleaning detergent.
This product can be used with and without detergent.
WARNING:
To reduce the risk of personal injury, unplug the stick steam mop when filling the unit.
Remove the clean
water/detergent tank
at the front of the unit.
Twist the water cap
slightly anti-clockwise
to remove.
Fill the water tank with max
750ml of water and replace
the water cap. Tighten by
twisting clockwise.
Replace the tank, clicking into
place making sure the hard
water filter is in place. Do not
use steam mop without tanks
in place
IMPORTANT:
Your detergent control dial will be set to ‘tough stains’ when you remove your steam mop from the box.
If you do not want to use detergent on your flooring, this must be rotated to ‘steam/refreshes carpets only’ position.
Always test on an inconspicuous area of flooring first before using detergent.
NOTE:
Do
not over fill.
NOTE:
Do
not over fill.
IMPORTANT:
Please refer to floor manufacturer’s care recommendations before use and test the steam mop on a
discrete area of flooring to begin with.
S3S-U series UG - 15.08.13_User guide 29/08/2013 10:15 Page 5
