13
Cleaning and maintenance
To remove any threads or hair, slide
the blade of a pair of scissors into the
groove on the brushbar and cut along
the groove.
IMPORTANT: If the brushbar or brushroll has been obstructed, the motor protection sensor may
activate. The brushes will stop and the light on the powered floorhead will illuminate red. Switch off
the machine, clear any obstruction and wait 1 minute before reactivating.
NOTE: For best performance and to reduce hair and dirt build up, remove and clean the brushbars
every 1-2 months (depending on the level of use).
Pull the brushbar out from the
brush housing.
Clear any dirt/debris from the end caps
and inside the brush housing.
Using a coin, push and turn the
brushbar cover anticlockwise to the
unlock symbol.
Refit the brushbar into the floorhead.
Align the arrow on the brushbar cover to
the unlock symbol, push firmly until the
cover sits flush and turn to lock into place.
Removing and cleaning the floorhead brushbar
Summary of Contents for Edge Pet & Car CLUP-EGKS
Page 1: ...CLUP EGKS CLUP EGBC User Guide VAX Edge Pet Car Cordless Vacuum...
Page 20: ...18 Notes...
Page 21: ...19 Notes...