Assembling your machine
Insert the hose into the
hose port so that it clicks
into place.
Connect the handle to the
telescopic tube and adjust
the length of the telescopic
tube.
Connect the telescopic
tube to the combination
floorhead.
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Getting started
IMPORTANT:
The condition of the filters affects the performance of your machine. Please check and clean filters
periodically (depending on the level of use). For full cleaning instructions, see ‘Taking care of your machine’.
Before you begin cleaning
• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug it from the
electrical socket. Remove and empty the dirt container and also check the vacuum cleaner for blockages. Allow the vacuum
cleaner to cool for approximately 1 hour
• If you have cleaned the filters please wait 24 hours for the filters to fully dry before putting back into the vacuum).
• Pre-motor filter requires cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
• When using the accessories always make sure the brushbar is switched to the ‘off’ position.
IMPORTANT:
The base of the vacuum cleaner should always be positioned flat on the floor when starting and in use.
The dirt container should be locked into place before lifting the vacuum cleaner by the carry handle.
