© Copyright 2015 Vauni AB - All rights reserved
Vauni Divider
|
13
ENG
The coating is removed with the following steps:
• If the hearth has been used, it must be allowed to cool until the burner has reached room
temperature.
• Remove the regulator lid by lifting it straight up.
• Scrape off any coating around or inside the burner tray, using a rubber or plastic scraper. Take
special care around the burner matrix, and see that no particles fall down into the combustion
chamber or block the holes in the burner matrix.
• Remove the scraped-off coating by using a vacuum cleaner.
• Clean the area around the burner tray’s opening with a moist rag. If it is very dirty, a mild
detergent can be used sparsely. In this case, be very careful that the liquid does not run down
into the burner matrix or make contact with the surrounding slab.
• Scrape off any coating from the regulator lid, then clean it off with a moistened rag. If it is very
dirty, a mild detergent can be used sparsely.
• Place the regulator lid by lowering the two guide pins into the respective grooves. When
correctly placed, the regulator lid should lie closely against the burner’s surface and slide
easily when the regulator rod (which grips in the holes provided in the regulator lid) moves it
to its respective stop.
6.3 Slab parts
The metal- and granite slab require some carefulness in order to avoid discolouring. This applies
especially to spilled fuel, since denatured alcohol is a very strong solvent. To avoid discolouring,
therefore, any spilled fuel must immediately be wiped off with a dry rag.
Continuous cleaning of the slab should be done only with a dry rag or similar material.
Summary of Contents for Divider
