6
|
Vauni Divider
© Copyright 2015 Vauni AB - All rights reserved
ENG
3 INSTALLATION
The hearth is designed to allow flexible placement in most interiors, and requires a minimum of
assembly and installation before it can be used. To ensure that the hearth’s full safety is utilized,
it is important that the instructions below for assembly be followed when the hearth is installed.
Keep in mind!
The hearth is certified to be placed in a space with a minimum volume of 32 m
3
(an equivalent
floor area is 13 m
2
) and with normal ventilation (0,5 exchange of air per hour). It is important that
the placement is chosen so that the flame is not exposed to direct draught, and places should be
especially avoided where the draught’s direction is against the hearth’s opening. Inflammable
objects must not be placed within 1 metre from the hearth. Remember that curtains and similar
objects must have a safety margin of at least 1 metre due to risk of draught currents. (Figure 6)
3.1 Assembly and installation
The Divider is to a large extent assembled already when delivered, and needs only minor post-
assembly and installation. Follow the steps below to assemble and install the product. Vauni
recommends that the assembly is done by two persons, since some steps require heavy lifting.
Note!
Depending on the market and model variants, minor deviations may occur.
Preparations:
1. Remove the hearth and its accessories from the packaging and check the details for possible
transport damage. Any damage must be reported immediately to the deliverer and to the place
of purchase.
2. Check that all the parts and standard accessories specified in Section 2 are included.
3. Check that you have the right tools; see
Section 8, Technical specifications.
(Figures 10, 11)
Assembly:
4. Lower the burner in the provided holder into the hearth. (Figure 1)
5. Place the regulator lid by lowering the two guide pins into the respective grooves (Figure
10A). When correctly placed, the regulator lid should lie closely against the burner’s surface
and slide easily when the regulator rod (which grips in the holes provided in the regulator lid)
moves it to its respective stop. In the open position, the regulator lid must be entirely to the left
(or right) of the burner tray’s opening as seen from the hearth’s open short side. Ensure that
the holes in the regulator lid always point outward when in the open position. (Figur 3, 4)
1
2
3
Summary of Contents for Divider
