7)
Install the crank handle onto the shaft on top of the chamber. Align set screw to the flat on shaft and tighten
with
1/8”
allen wrench. Raise heaters to full up position.
6)
The belt needs to be tightened and adjusted. To tighten and
adjust the belt, use the Aligner Bolts. To raise the Aligner,
turn the Aligner Bolt clockwise with a
7/16”
wrench. To lower
it, turn it counter clockwise. Start with the belt centered on
the pulley.
6
Aligner Bolt
Assembly
(cont’d)
8)
The
4”
exhaust stack should be vented outside. Exhaust ducting should not restrict air flow. Ducting should create
no more than 10% decrease in exhaust CFM. See
Dryer and Exhaust Hood Ducting
for more information.
9)
Have a licensed electrician complete the electrical hook
-
up and fill out the warranty card. Send it back to Vastex to
validate your warranty. A wiring diagram has been included with this manual. One is also adhered to the inside of
the control box cover.
(Note: Restricting the dryers exhaust can affect the operation of the dryer causing excessive heat
buildup within the chamber and fumes to fill the chamber and work area. The excessive heat buildup in
the chamber may damage the dryers exhaust blower. Proper venting is important.)
5)
The belt needs to be installed as shown in the diagram below. Be sure the belt is routed over all braces on the con-
veyor and over the Aligner. To connect your belt, align the Alligator Lace and install the pin. Position it as shown in
the diagram.
Alligator lace
Aligner
Brace
5
5
Belt Travel
Belt
Alligator Lace
Do not tighten this nut!
Pg. 5