Varytec Giga Bar Pix 8 RGB, User Manual

Page: 37 / 64

This setting is only relevant when the device is controlled via DMX.
Press
[MODE] repeatedly until the display shows ‘dxxx’ . Press [SETUP] . Now use [UP] and
[DOWN] to select one of the following DMX operating modes:
n
‘2-ch’ (two channels)
n
‘3-ch’ (three channels)
n
‘5-ch’ (five channels)
n
‘24Ch’ (twenty-four channels)
Wait about 30 seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [MODE] .
This setting is only relevant if the device is serving as Slave in a Master / Slave configuration
and is not controlled via DMX.
Press
[MODE] until the display shows ‘SLAv’ .
Wait about 30 seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [MODE] .
DMX mode
Operating mode ‘Slave’
Operating
Giga Bar Pix 8 RGB Giga Bar Frost Pix 8 RGB
37
LED bar